|
In camera design, a focal-plane shutter (FPS) is a type of photographic shutter that is positioned immediately in front of the focal plane of the camera, that is, right in front of the photographic film or image sensor. ==Two-curtain shutters== The traditional type of focal-plane shutter in 35 mm cameras, pioneered by Leitz for use in its Leica cameras, uses two shutter curtains, made of opaque rubberized fabric, that run horizontally across the film plane. For slower shutter speeds, the first curtain opens (usually) from right to left, and after the required time with the shutter open, the second curtain closes the aperture in the same direction. When the shutter is cocked again the shutter curtains are moved back to their starting positions, ready to be released. Focal-plane shutter at low speed ''Figure 1:'' The black rectangle represents the frame aperture through which the exposure is made. It is currently covered by the first shutter curtain, shown in red. The second shutter curtain shown in green is on the right side. ''Figure 2:'' The first shutter curtain moves fully to the left allowing the exposure to be made. At this point the flash is made to fire if one is attached and ready to do so. ''Figure 3:'' After the required amount of exposure the second shutter curtain moves to the left to cover the frame aperture. When the shutter is recocked the shutter curtains are wound back to the right hand side ready for the next exposure. This is a graphical representation only; the actual mechanisms are much more complex. For example, the shutter curtains actually roll on and off spools at either side of the frame aperture so as to use as little space as possible. Faster shutter speeds are achieved by the second curtain closing before the first one has fully opened; this results in a vertical slit that travels horizontally across the film. Faster shutter speeds simply require a narrower slit, as the speed of travel of the shutter curtains is not normally varied. Using this technique, modern SLR cameras are capable of shutter speeds of up to 1/2000, 1/4000 or even 1/8000 of a second. Focal-plane shutter at high speed ''Figure 1:'' The black rectangle represents the frame aperture through which the exposure is made. It is currently covered by the first shutter curtain, shown in red. The second shutter curtain shown in green is on the right side. ''Figure 2:'' The first shutter curtain begins to move to the left allowing the exposure to be made. Because the exposure requires a very fast shutter speed, the second curtain begins to move across at a set distance from the first one. ''Figure 3:'' The first shutter curtain continues to travel across the frame aperture followed by the second curtain. It would be pointless to use an electronic flash with this shutter speed as the short duration flash would only expose a very small amount of the frame as the rest is covered by either the first or second shutter curtain. ''Figure 4:'' The first shutter curtain finishes moving, followed closely by the second curtain which is now covering the frame aperture completely. When the shutter is recocked both shutter curtains are wound back to the right hand side ready for the next exposure. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Focal-plane shutter」の詳細全文を読む スポンサード リンク
|